Yamaha RS Venture RST9NJ Owner's Manual page 66

Periodic maintenance and adjustment
1
1. Fastener
2. Left side cover
To install a side cover
1. Fit the projection on the rear of the side
cover into the hole in the fuel tank cover.
2. Fit the projections on the side cover into
the slots as shown.
3. Tighten the fasteners.
4. Install the shroud.
60
Top cover
2
To remove the top cover
1. Remove the shroud and the left side cov-
er. (See the above procedures.)
2. Disconnect the auxiliary DC jack coupler.
1. Auxiliary DC jack coupler
3. Remove the screws, and then remove
the cable guide.
1. Screw
2. Cable guide
4. Pull the windshield stay rubber covers
upward.
1
1
2