Installing The Spacer; Installing The Timing Chain; Installing The Primary Gear - Husqvarna FE 250 EU 2014 Repair Manual

ENGINE
18
18.5.7

Installing the spacer

18.5.8

Installing the timing chain

18.5.9

Installing the primary gear

-
Grease the shaft seal ring.
0-
-
Mount spacer
O
-
Mount balancer shaft
• Info
I
If the timing chain was used before, ensure it is running in the correct
direction.
-
Mount and tighten screw
Guideline
Screw, timing chain
securing guide
-
Position timing chain guide rail
-
Mount and tighten screw
Guideline
Screw, timing chain guide
rail
-
Position timing chain tensioning rail
-
Mount and tighten screw (D.
Guideline
Screw, timing chain ten­
sioning rail
0-
Position primary gear
f)
✓ Markings and G) are aligned.
-
Set the crankshaft to top dead center and lock it with screw
fD.
-
Mount and tighten nut
Guideline
Nut, primary gear
with the timing chain and timing chain securing guide.
8.
M6 10 Nm
(7.4 lbf ft)
8 .
C,.
M6 10 Nm
(7.4 lbf ft)
0 -
M8 15 Nm
(11.1 lbf ft)
M18LHx1 .5 100 Nm
(73.8 lbf ft)
176
Loctite ® 243
™
Loctite ® 243
™
Loctite 243
® ™
8.
Loctite 243
® ™