Left Engine Case, Installing; Installing The Spacer - Husqvarna FC 250 2017 Repair Manual

17.5.6

left engine case, installing

17.5.7

Installing the spacer

-
Mount the dowels.
-
Degrease the sealing area. Apply sealing compound to the
left section of the engine case.
I
Loctite 5910
®
-
Mount the left section of the engine case. If necessary, strike
it lightly with a rubber mallet and turn the transmission shafts.
• Info
I
Do not use the screws to pull the two sections of the
engine case together.
O,
Mount screws but do not tighten yet.
Guideline
I I
Screw, engine case
-
Mount screws @, but do not tighten yet.
Guideline
I I
Screw, engine case
(D
-
Mount screws and tighten all screws in a crisscross pat­
tern.
Guideline
I I
Screw, engine case
-
Mount the screw cap of the engine fixing arm.
-
Mount the O-ring on the countershaft.
-
Lightly grease and mount spacer
-
Grease the shaft seal ring.
I
Long-life grease (ll!:!I p. 292)
O.
-
Mount spacer
-
Set the crankshaft to top dead center and lock it with
screw@}.
I
M6x55 10 Nm (7.4 lbf ft)
M6x65 110 Nm (7.4 lbf ft)
M6x70 10 Nm (7.4 lbf ft)
8.
ENGINE 17
...
219