Cleaning The Spark Arrestor (Fe Us) - Husqvarna FE 250 EU 2014 Repair Manual

EXHAUST
10
Cleanin the spark arrestor (FE US)
Warning
The exhaust system gets very hot when the vehicle is driven.
Danger of burns
-
Allow the exhaust system to cool down before performing any work on the vehicle.
Info
Soot particles accumulate on the screen of the spark arrestor over time.
This changes the performance characteristics.
Preparatory work
-
Remove the right side cover.
-
Remove the main silencer.
(FE US)
-
Remove screws
-
Remove connecting cap with the perforated pipe, O-ring
yarn filling
-
Remove screws
-
Remove screws G) and insert
-
Remove the insulating pad from the insert.
-
Clean the parts that need to be reinstalled and check for damage.
-
Mount the new insulating pad on the insert and fasten with adhesive tape.
-
Position the insert with the insulating pad in outer tube
Mount and tighten screws G).
Guideline
I
Screws on the main silencer
-
Mount O-ring
Fit the new glass fiber yarn filling onto the perforated pipe.
Fit the connecting cap with the glass fiber yarn filling in the outer tube.
•
I
-
Mount and tighten screws
Guideline
I
Screws on the main silencer
-
Mount O-ring @ on the silencer cap.
-
Position the silencer cap with O-ring @ in the outer tube.
-
Mount and tighten screws@).
Guideline
I
Screws on the main silencer
Finishing work
-
Install the main silencer.
-
Install the right side cover.
(l!!,!l p. 75)
(l!!,!l p. 69)
O
of connecting cap
8.
0
and silencer cap (3 with O-ring @.
@)
together with insulating pad G,i).
(D on the silencer cap.
Info
Press the glass fiber yarn filling into the outer tube using a blunt tool.
O.
(l!!,!l p. 70)
(l!!,!l p. 76)
8.
(D , and glass fiber
41.
I
MS I 7 Nm (5.2 lbf ft)
I
MS I 7 Nm (5.2 lbf ft)
I 7 Nm (5.2 lbf ft)
71