Table of Contents
Advertisement
Chapter 2
Installing the IDS-4210
Installing and Removing the Bezel
Step 1
Step 2
Installing Center Mount Brackets
Step 1
Step 2
Cisco Intrusion Detection System Appliance and Module Installation and Configuration Guide Version 4.1
78-15597-02
Documentation and software
•
–
Cisco IDS recovery/upgrade CD
Cisco Documentation CD
–
–
Cisco Intrusion Detection System (IDS) Hardware and Software Version
4.1 Documentation Guide
–
Regulatory Compliance and Safety Information for the Cisco Intrusion
Detection System 4200 Series Appliance Sensor
You can install a Cisco bezel for the IDS-4210.
To install and remove the bezel on the IDS-4210, follow these steps:
To insert the bezel on the appliance, follow these steps:
a.
Align the bottom tabs on the bezel with the slots on the appliance.
b.
Align the side tabs on the bezel with the slots on the appliance.
Press the bezel into the appliance.
c.
To remove the bezel from the appliance, press the side tabs and pull.
You need the following tools and supplies to install the brackets in a two-post,
open-frame relay rack:
•
#2 Phillips screwdriver
Masking tape or felt-tip pen to mark the mounting holes to be used
•
To install the center mount brackets in a two-post, open-frame relay rack, follow
these steps:
Determine where you want to place your appliance.
Mark the upper and lower mounting positions on the two posts.
Installing the Accessories
2-9
Advertisement
Table of Contents
Troubleshooting
