Installation Procedures; Unpacking Precautions; Delivery Inspection; Shipment Contents - Briggs & Stratton 40213 Installation And Start-Up Manual

INSTALLATION
PROCEDURES

Unpacking Precautions

The unit is shipped bolted to its mounting pad, ready for
installation. Avoid damage from dropping, bumping, collision,
etc. Store and unpack carton with the proper side up, as
noted on the shipping carton.
CAUTION
Installing the 15A fuse could cause the engine to start.
• Observe that the 15 Amp fuse has been removed from the
control panel for shipping.
• DO NOT install this fuse until all plumbing and wiring has
been completed and inspected.

Delivery Inspection

After removing the carton, carefully inspect the Home
Generator System for any damage that may have occurred
during shipment.
IMPORTANT: If loss or damage is noted at time of
delivery, have the person(s) making delivery note all damage
on the freight bill and affix his signature under the
consignor's memo of loss or damage. If loss or damage is
noted after delivery, separate the damaged materials and
contact the carrier for claim procedures. Missing or
damaged parts are not warranted.

Shipment Contents

The Home Generator System is supplied with:
• Home Generator System
• Pre-attached mounting pad
• One 24" flexible hook-up hose
• Installation and start-up manual
• Operator's manual
• Illustrated parts list manual
• Installation checklist
• Two access door keys
• Four lifting hole plugs
• Oil fill spout
• One spare 15A fuse
• 2 Pole connector - 240V from house
• 10 Pole connector - Sensing and control wires
• Air intake engine cover
• Alternator cover
• Diagnostic LED kit (red LED/plate/screws (2))
INSTALLATION

Required Specialty Tools/Equipment

• Two 48" lengths of 1" OD pipe (NOT conduit)
• Hole punches for 16ga steel
• Torque screwdriver, 5 to 50 inch-pound range

Home Generator System Location

Before installing generator, consult with homeowner and
convey the following guidelines which may affect the
desired location.
Generator Clearances
Exhaust heat/gases can ignite combustibles or
structures causing a fire.
• Keep at least 5 ft. (152 cm) clearance on all sides of generator
including overhead.
Place generator in a well ventilated area, which will allow for
removal of deadly exhaust gas. DO NOT install generator
where exhaust gas could accumulate and enter inside or be
drawn into a potentially occupied building. Ensure exhaust gas
is kept away from any windows, doors, ventilation intakes or
other openings that can allow exhaust gas to collect in a
confined area (Figure 1). Prevailing winds and air currents
should be taken into consideration when positioning generator.
Running generator gives off carbon monoxide,
an odorless, colorless, poison gas.
Breathing carbon monoxide will cause nausea,
fainting or death.
• Operate generator ONLY outdoors.
• Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
Figure 1 — Home Generator System Clearances
Exhaust port must be
5 ft (152 cm)
minimum distance
from building openings
4
WARNING
WARNING
Exhaust Port