Denon AVC-X3700H Owner's Manual page 189

Contents
HDCP Setup
Sets the HDCP version for each HDMI input source.
Video may not be output depending on the HDCP version of your player
and the TV.
If this issue occurs, use this setting to set one version of HDCP. This may
be able to output video.
Auto
(Default):
1.4:
2.3:
0 "Custom" is displayed for the setting item if our service engineers or custom
installers has configured the HDCP version for this unit.
Front panel
Downloaded from ManualsNet.com
Connections Playback
Automatically applies the HDCP version of
this unit according to TV.
Fixes the HDCP version of this unit to 1.4.
Fixes the HDCP version of this unit to 2.3.
Display Rear panel
search engine
Settings
TV Format
Set the video signal format to be output for the TV you are using.
o Format
PAL
(Default):
NTSC:
0 "Format" can also be set by the following procedure. However, the menu
screen is not displayed. Following the display content to make the setting.
1. Press and hold the main unit's ZONE2 SOURCE and STATUS at the same
time for at least 3 seconds.
"V.Format:<PAL>" appears on the display.
2. Use the main unit's SOUND MODE or PURE DIRECT and set the video
signal format.
3. Press the main unit's STATUS to complete the setting.
NOTE
0 When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
189
Remote
Tips Appendix
Select PAL output.
Select NTSC output.
Index