Configuration; Overview: Configuration; Making Field Settings; About Making Field Settings - Daikin RDXYQ5T8V1B Installer And User Manual

18 Configuration

In this chapter

18.1 Overview: Configuration

18.2 Making field settings

18.2.1 About making field settings

RKXYQ5T8+8T7Y1B + RDXYQ5T8+8T7V1B
VRV IV heat pump for indoor installation
4P499898-1B - 2021.12
18.1 Overview: Configuration.........................................................................................................................................................
18.2 Making field settings...............................................................................................................................................................
18.2.1 About making field settings ...................................................................................................................................
18.2.2 To access the field setting components ................................................................................................................ 100
18.2.3 Field setting components....................................................................................................................................... 100
18.2.4 To access mode 1 or 2............................................................................................................................................ 102
18.2.5 To use mode 1 (and default situation) .................................................................................................................. 103
18.2.6 To use mode 2........................................................................................................................................................ 104
18.2.7 Mode 1 (and default situation): Monitoring settings............................................................................................ 105
18.2.8 Mode 2: Field settings............................................................................................................................................ 109
18.2.9 To connect the PC configurator to the compressor unit ...................................................................................... 113
18.3 Energy saving and optimum operation.................................................................................................................................. 113
This chapter describes what you have to do and know to configure the system after
it is installed.
It contains information about:
▪

Making field settings

▪ Energy saving and optimum operation
INFORMATION
It is important that all information in this chapter is read sequentially by the installer
and that the system is configured as applicable.
DANGER: RISK OF ELECTROCUTION
To configure the heat pump system, you must give input to the compressor unit's
main PCB (A1P). This involves the following field setting components:
▪ Push buttons to give input to the PCB
▪ A display to read feedback from the PCB
▪ DIP switches (only change the factory settings if you install a cool/heat selector
switch).
Field settings are defined by their mode, setting and value. Example: [2-8]=4.
PC configurator
You can also make field settings through a personal computer interface (for this,
option EKPCCAB* is required). The installer can prepare the configuration (off-site)
on PC and afterwards upload the configuration to the system.
See also: "18.2.9 To connect the PC configurator to the compressor
18 Configuration
|
99
99
99
4
unit" [ 113].
Installer and user reference guide
99