Changing Your Workstation's Hardware Configuration
Installing the Optional Fast Wide Differential SCSI Controller
6 Connect the end of FWD SCSI cable to the FWD SCSI controller making sure
To FWD SCSI Controller
Ferrite Bead
Cable Clip
Figure 67
Installing the FWD SCSI Cable
7 Set the ferrite bead into the slot on the side of the storage tray. Make sure that the
8 Use the two hex standoffs to install the external connector on the end of the FWD
9 Secure the cable in the cable clip so that it does not interfere with the disk drives,
166
that the red line on the cable is toward the rear (away from the fans) of the main
tray, as shown in Figure 67.
cable is dressed so that it will not be damaged by the storage tray cover
SCSI cable into the rear panel of the storage tray, as shown in Figure 67.
as shown in Figure 67.
Red Line
External Connector