Installing The Scsi Controller; Figure 55. Qlogic 1280* Scsi Adapter - HP i2000 Owner's Manual

8.4

Installing the SCSI Controller

Use the following steps to install the SCSI controller to the system.
/
NOTE
The WXB PCI buses (S2 and slots 1, 2, 3, and 4) support 3.3 V cards, while the
PXB PCI bus (slots 5 and 6) support 5 V cards. Both WXB and PXB PCI buses
support universal cards. Please make certain that the PCI slot used is
compatible with the PCI card inserted in that slot.
/
NOTE
For continued EMC compliance of the system, use only those peripheral devices
having an external output connector (i.e., audio, video) which are marked as FCC
tested for home or office use (FCC Class B), and marked as Canada ICES-003
Class B compliant. For European installations, these devices are required to be
CE marked with declaration of conformity to the EMC directives (89/336/EEC).
1. Insert the Qlogic* SCSI controller into a PCI slot (slot 3 recommended, refer to
Figure 49) making sure that the controller is completely seated. Install the
retaining screw.
2. Attach the 68-pin SCSI cable connector (labeled P1) to the top connector of the
Qlogic* controller (labeled J3). Refer to Figure 54 and
3. Figure 55.
100

Figure 55. Qlogic 1280* SCSI Adapter

hp workstation i2000 owner's guide
Drive activity cable
should be attached
to J9