Hardware Installation For Drives; Removing The Mass Storage Module; Removing A Device From The Mass Storage Module - HP 9000 Series Owner's Manual

Hardware Installation for Drives

Tools Required
You'll need these tools to access the mass storage devices:
Medium at-tipped screwdriver.
No. 1 Phillips screwdriver.
Static-free work area.

Removing the Mass Storage Module

1. Modules can only be removed from the back.
If your system is rack-mounted front side out, and there is not enough room
to remove a module from the back, remove the system from the rack.
5
2. Unplug the SCSI cables attached to the system module's SCSI connector
and the mass storage module's SCSI connector.
3. Inside the handle for each module is a slotted screw. Unscrew the screw
about 7 turns (until it pops out), then pull out the mass storage module.

Removing a Device from the Mass Storage Module

Before you can change the con guration for a device, you will need to remove
the drive from the mass storage tray. Follow these steps to remove the drive.
Caution
1. Remove the screw at the rear of the mounting bracket for the drive.
2. Slide the bracket back about 12mm (0.5-in.) to unlock the bracket tabs,
then lift the bracket with attached drive up and out of the tray.
5-8 Configuring HP-UX for Printers and Drives
Hard disk drives are vulnerable to physical shock.
hard disk drive from even a small height will damage its heads
and platters.
Always handle hard disk drives with extreme caution.
Do not place a hard disk drive upside down on any surface.
Dropping a
DRAFT
2/5/97 11:31