Table of Contents
Advertisement
Symptom of Misadjustment:
The convergence on the screen will vary.
1. Connect the Personal Computer to the RGB1 IN with the VGA
cable.
2. Supply Crosshatch Pattern Signal and project on the screen.
3. (R-G Convergence Adjustment)
Loosen 2 Hexagon screws (A) of LCD RED Unit as shown in
-4-18
Grasp the Adjust Plate (a) and move the plate so that the
Red line exactly overlaps the Green line as shown in
4. Tighten 2 Hexagon screws (A) with a Hexagon Wrench.
5. (B-G Convergence Adjustment)
Loosen 2 Hexagon screws (B) of LCD BLUE Unit as shown in
4-4-18
Grasp the Adjust Plate (b) and move the plate so that the
Blue line exactly overlaps the Green line as shown in
6. Tighten 2 Hexagon screws (B) with a Hexagon Wrench.
Fig. 4-4-18
Fig. 4
Fig.
4-4-19.
Fig.
Fig.
4-4-19.
Advertisement
Table of Contents
