Table of Contents
Advertisement
3. After completing adjustments 4.4.14 through 4.4.17, press the "
MENU" button to release from "Video/Rgb Adjust" mode.
After completing adjustments;
Press the MENU button to release from the Factory Adjust mode. (The factory adjust mode
screen shown in
Fig. 4-4-3
once.
While "Please press POWER button again to power off." is displayed, press the
on remote control to power off.
Then, all adjustment data is memorized in EEPROM IC's (IC6009, IC6010).
Note:
Do not turn off the Main Power SW before doing above. / Otherwise,
all adjustment data will be cancelled.
4.4.1. LCD COMMON ADJUSTMENT
Purpose:
To set the optimum LCD common voltage.
Symptom of Misadjustment:
The picture will be bluish or reddish.
Note:
This adjustment should be done in a darkroom.
disappears.) / Then, press the POWER button on remote control
POWER
button
Advertisement
Table of Contents
