Table of Contents
Advertisement
Assembly Note:
1. After replacing the Polarizer, LCD convergence adjustment is
necessary (Refer to 4.1. Initial Guide Line).
2. The side of Polarizer Sheet should face to the LCD.
3. Put the holes of Polarizer Holders into the projections of LCD
Hold Plate so that the Polarizer dose not shake.
4. The Polarizer should be held tight by the Polarizer Holders when
installing in the LCD Hold Plate.
3.4.5. Removal of the Projection Lens
1. Remove 4 screws (F) to remove the Projection Lens as shown in
Fig.
3-4-6.
Note:
Make sure that no dust gets on the Projection Lens. Clean the Projection Lens with cleaning
paper moistened with lens cleaner if necessary.
(Refer to 2.5. Cleaning the Projection Lens.)
Fig. 3-4-5
Fig. 3-4-6
Advertisement
Table of Contents
