Table of Contents
Advertisement
7. While "Please press POWER button again to power off." is
displayed, press the MENU button on remote control.
8. The Factory Adjust Mode appears on screen.
9. Perform adjustments 4.4.1 through 4.4.5 and 4.4.12 through 4.4.17.
10. After completing all adjustments, press the MENU button to
release from the Factory Adjust Mode.
11. Press the POWER button on remote control once.
12. While "Please press POWER button again to power off." is
displayed, press the
off. Then, all adjustment data is memorized in EEPROM IC's.
Note:
1. When initializing EEPROM IC's, memory data such as history of
lamp operation time and adjustment data will be reset.
2. When "MEMORY NG" appears in step 5, repeat step 3 through
step 5 until "MEMORY OK" appears.
2.4. Lamp replacement procedure
Caution:
Lamp replacement procedure Caution: Because of possibility of
injury, strictly follow the replacement procedure below.
1. After the cooling fan has stopped, and STANDBY(R) ON(G)
indicator turns solid red. Set the Main Power Switch to OFF and
unplug the power cord.
Note:
Please wait more than one hour for lamp replacement.
[ If you need to replace the lamp more urgently ]
- The LCD Projector has a forced cooling feature. After the
POWER switch is turned OFF, and sometime during about the
first minute of the normal cooling fan operation, press
POWER
button on remote control to power
and
Advertisement
Table of Contents
