Replacing The System Board - HP BRIO BA410 Manual

Replacing the System Board

1 Switch off the PC and remove the PC's main cover (refer to page 49).
2 Lay the PC on its side.
3 Remove the power supply unit to gain better access to the inside of the
PC (refer to page 51).
4 Remove all cables and expansion cards from the system board.
5 Remove the seven screws shown below.
6 Lift the system board up slightly, then pull it carefully away from the
rear panel and lift it out of the PC.
7 Remove any components you want to reuse such as the processor or
memory modules. Refer to the appropriate section for instructions on
removing the individual components.
8 Install any components removed from the old system board in the new
board. Refer to the appropriate section if you require instructions on
installing the individual components.
9 Replace the system board in the PC, ensuring that the rear connectors
on the system board are correctly engaged in the corresponding holes
at the rear of the PC.
All manuals and user guides at all-guides.com

Replacing the System Board