Replacing Drives; Replacing A Hard Drive; Removing A Hard Drive; Installing A 2.5 Inch Hard Disk Drive - HP ProOne 600 Hardware Reference Manual

Replacing drives

Replacing a hard drive

The 2.5 inch primary hard drive is installed on the right side of the computer. To locate the hard drive on the
system board, see

Removing a hard drive

1. Remove the screw securing the hard drive to the computer.
2. Slide the hard drive away the edge of the computer and lift the hard drive out of the computer.
3. Disconnect the power and data cables from the hard drive. There is a tab you can pull to disconnect
these cables.
4. Remove the four mounting screws from the 2.5 inch hard drive cage (1). Be sure to keep the screws to
use to install a replacement drive. Remove the hard drive (2).
For instructions on installing a hard drive, see

Installing a 2.5 inch hard disk drive

1. Insert the hard drive into the drive cage (1) and fasten four mounting screws onto the new 2.5 inch hard
drive (2).
2. Position the hard drive above the drive cage with the connectors facing the power and data cables.
Locating internal components on page 23.
Installing a 2.5 inch hard disk drive on page 27.
Replacing drives 27