Table of Contents
Advertisement
3. PARAMETERS
3. PARAMETERS
CAUTION
3.1 Parameter list
Never make a drastic adjustment or change to the parameter values as doing so
will make the operation unstable.
If fixed values are written in the digits of a parameter, do not change these values.
Do not change parameters for manufacturer setting.
Do not set any values other than the described setting values to each parameter.
POINT
When you connect the servo amplifier to a servo system controller, servo
parameter values of the servo system controller will be written to each
parameter.
Setting may not be made to some parameters and their ranges depending on
the servo system controller model, servo amplifier software version, and MR
Configurator2 software version. For details, refer to the servo system controller
user's manual. Check the software version of the servo amplifier with MR
Configurator2.
POINT
The parameter whose symbol is preceded by * is enabled with the following
conditions:
*: After setting the parameter, cycle the power or reset the controller.
**: After setting the parameter, cycle the power.
For servo amplifier with software version B3 or later, the parameter initial values
for the manufacturer setting are partially changed.
3 - 1
Advertisement
Table of Contents
