Record - EverFocus H265 Series User Manual

Value ip network camera

Hide thumbs Also See for H265 Series:

Table of Contents

3.3.2

Record

3.3.2.1

Record

You can configure the record settings on this page. Please note that to enable the record function, a micro

SD card has to be inserted to the IP camera in advance. Please also format the micro SD card for the

first-time use (refer to 3.6.1 HDD).

Stream Mode: Select a recording stream mode.

Record: Switch the button to the right to enable the record function. Please note that to enable the

record function, a micro SD card has to be inserted to the IP camera in advance. Please also format the

micro SD card for the first-time use.

Pre-Record: Switch the button to the right to enable the pre-record function for all the alarm recordings.

The camera will start recording 10 seconds before the alarms occur.

Network Failed: Switch the button to the right to enable the network failed function. When the network

is disconnecting, the IP camera will start recording until the network connection is back to normal.

Click Refresh to refresh the page; click Save to save the settings.

Note:

To configure the recording storage path, please refer to 3.8.5 Local Settings.

After setting up the Record settings, you can optionally set up the Record Schedule, please refer to

3.3.2.2 Record Schedule.

Value IPCam-SG Series – H265, 2MP / 5MP / 8MP

Table of Contents