Table of Contents
Advertisement
OVERREVVING SETTING
Standard overrevving values are normally already set in the multifunctional display. If
you wish to set a lower value, follow the steps outlined below when the vehicle and
the engine are at a standstill:
•
Press the MODE and SCROLL buttons at the same time for more than 5
seconds. Five noughts (00000) will be displayed in the B area, with the first
nought blinking.
•
Each time the MODE button is pressed, the value of the blinking number is
increased by one unit.
02_14
Not touching the control for two seconds causes the value to be memorised and moves
the system on to the adjustment of the subsequent digit; Follow the same procedure
to set the second and third digits. Memorise the new values as before, by not activating
any controls for two seconds. The last two noughts cannot be modified. If the value
set is correct, i.e. lower than the maximum overrevving value, you can be memorise
it by holding the SCROLL button down longer than two seconds. If you go over the
threshold value, the warning light «3» on the instrument panel starts to blink until you
go below the threshold value again.
02_15
BATTERY ICON
The battery icon comes on when the battery charge is too low. If it is displayed during
the vehicle regular operation, check the battery charge status and recharge the sys-
tem. It is normal for the icon to be displayed before and during start-up, to then
disappear once the engine has started.
02_16
26
Advertisement
Table of Contents
