Table of Contents
Advertisement
•
After a repair or periodic maintenance operation, carry out the preliminary
checks and test the vehicle on private property or in an area with light traffic.
•
Clean all coupling surfaces, oil seal rims and gaskets before refitting them.
Smear a light layer of lithium-based grease on the oil seal rims. Reassemble
oil seals and bearings with the brand or lot number facing outward (visible
side).
ELECTRICAL CONNECTORS
The electrical connectors should be disconnected as follows. Failure to observe these
procedures will cause irreparable damage to the connector and the wiring:
If present, press on the specific safety catches.
•
Grip the two connectors and unplug them, pulling them apart in opposite di-
rections.
•
If there is dirt, rust, moisture, etc., carefully clean the inside of the connector
using pressurised air.
•
Ensure that the cables make correct contact with the terminals inside the
connectors.
•
Then plug in the two connectors, ensuring correct coupling (if the specific
catches are present, you will hear a typical "click").
CAUTION
TO UNPLUG THE TWO CONNECTORS, DO NOT PULL ON THE CABLES.
NOTE
THE TWO CONNECTORS CAN BE PLUGGED IN ONLY IN ONE DIRECTION,
THEREFORE JOIN THEM TOGETHER IN THE RIGHT DIRECTION.
TIGHTENING TORQUE
CAUTION
REMEMBER THAT THE TIGHTENING TORQUE FOR ALL THE FIXING ELE-
MENTS LOCATED ON WHEELS, BRAKES, WHEEL AXLES AND OTHER SUS-
13
Advertisement
Table of Contents
