Power Connector Cable - HP Pavilion DV7-1020 Maintenance And Service Manual

Power connector cable

NOTE: The power connector cable is included in the Cable Kit, spare part number 480474-001.
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Switch cover (see
d. Keyboard (see
e. Speaker assembly (see
f. Display assembly (see
g. Top cover (see
h. System board (see
Remove the power connector cable:
1. Remove the power connector (1) from the clip built into the base enclosure.
2. Remove the power connector cable (2) from the routing channel built into the base enclosure.
Reverse this procedure to install the power connector cable.
Battery on page 51).
Hard drive on page 56)
Optical drive on page
Switch cover on page
Keyboard on page 68)
Speaker assembly on page
Display assembly on page
Top cover on page 82)
System board on page
54)
66)
72)
73)
91)
Component replacement procedures 99