Tv Tuner Module Cable - HP Pavilion DV7-1020 Maintenance And Service Manual

TV tuner module cable

NOTE: The TV tuner module cable is included in the Cable Kit, spare part number 480474-001.
Before removing the TV tuner module cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Switch cover (see
d. Keyboard (see
e. Speaker assembly (see
f. Display assembly (see
g. Top cover (see
h. System board (see
Remove the TV tuner module cable:
1. Remove the TV tuner module cable from the routing channel (1) built into the base enclosure.
2. Remove the TV tuner antenna connector (2) from the clip built into the base enclosure.
3. Remove the TV tuner module cable (3).
Reverse this procedure to install the TV tuner module cable.
Battery on page 51).
Hard drive on page 56)
Optical drive on page
Switch cover on page
Keyboard on page 68)
Speaker assembly on page
Display assembly on page
Top cover on page 82)
System board on page
54)
66)
72)
73)
91)
Component replacement procedures 101