Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
a.
memory module compartment cover (see
b.
Keyboard (see
c.
Top cover (see
Remove the power connector cable:
1.
Disconnect the power cable (1) from the system board.
2.
Release the power cable from the clips (2) built into the base enclosure.
3.
Remove the Phillips PM2.5×5.0 screw (3) that secures the power connector to the base enclosure.
4.
Release the power connector (4) from the clip built into the base enclosure.
5.
Remove the power connector cable.
Reverse this procedure to install the power connector cable.
Battery on page
37), and then remove the following components:
Keyboard on page
50)
Top cover on page
52)
Memory module on page
Component replacement procedures
Spare part number
617348-001
42)
59