7.
If it is necessary to replace the display enclosure or any of the display assembly internal
components:
a.
Remove the Mylar screw covers (1). The screw covers are included in the Display Screw Kit,
spare part number 603776-001.
b.
Remove the two Phillips PM2.5×5.0 screws (2) that secure the display enclosure to the
display assembly.
c.
Lift the bottom edge of the display bezel/panel assembly (1) until it rests at a slight angle.
d.
Disconnect the logo light cable (2) from the display panel cable.
e.
Release the wireless antenna cables (3) from the right display hinge.
72
Chapter 4 Removal and replacement procedures