Setting The Power Supply Used (Power Source) - Zoom ZF8N Operation Manual

Setting the power supply used (Power Source)

Set the external DC power supply shutdown voltage, nominal voltage and type of batteries so that the remaining power supply
charge can be shown accurately.
On this menu page, you can also check the voltage of each power supply and the remaining battery capacity.
1.
Press .
2.
Use to select
and press .
3.
Use to select
Source
, and press
▶ Continue to one of the following procedures.
Setting the external DC power supply (EXT DC) shutdown
voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . P .22
Setting DC power supply (Ext DC) nominal voltage. . . . . P .23
Setting the AA battery type (Int AA). . . . . . . . . . . . . . . . . . P .23
22
SYSTEM
,
Power
.
Setting the external DC power supply (EXT DC) shut-
down voltage
When an external DC power supply is being used, if the voltage
drops below the value set here, the
cording and turn off.
If AA batteries (Int AA) are installed, however, the power supply will
switch to Int AA and operation will continue.
4.
Shutdown
Use to select
Voltage
, and press
HINT
• The shutdown voltage is the voltage when the external DC power
supply runs out and can no longer supply power.
• See the manual for the external DC power supply for the shut-
down voltage value.
5.
Use to select the
voltage, and press
will automatically stop re-
.
.