Zoom ZF8N Operation Manual page 135

Correcting timecode errors after the power has been
turned off
When the mode of Start Timecode is set to RTC, turning the
power off lowers the timecode precision, but this function
can improve the error to the value close to 0.2 ppm when the
power has been turned off.
4.
RTC
Use to select
Timecode Calibration
press .
5.
Use to select
Recalibrate
, and press
6.
Yes
Use to select
press .
, and
.
, and
7.
Calibration completes.
8.
To cancel calibration, press
, and use
Yes, and press .
NOTE
• The is calibrated before being shipped new from the factory.
• After calibrating once, the result will be retained.
• If the
is moved to and used in an extremely hot or cold loca-
tion, timecode precision could change slightly when the power is
turned off. In such cases, we recommend calibrating it again.
• Calibration is not possible when Audio Interface with Rec is set
to On.
• Calibration is only possible when Start Timecode mode is set to RTC.
• Calibration is not possible when an
F8n
Multi Track Field Recorder
to select
is connected.
135