Table of Contents
Advertisement
on-CeIlIng mount tyPe InStallatIon examPle
y attaching the template and installing the install base
1. Attach the provided template on the ceiling. Based on the template, drill a 86mm hole in the
ceiling and arrange the wires through the hole.
2. Install installation base as shown.
3. Before installing the exposed bracket, open the hinged door at the bottom of the bracket as
shown in the picture. Hold the knob on the hinged door to open it.
J
`
In the case of installing the camera at highly humid place, install it on the ceiling after attaching the enclosed insulation sheet on
the back of install base.
y wiring terminal Cables
1. Connect the cables to the terminal block on the hinged door.
Refer to "Camera Wiring Interface Board". (page 16)
2. Once the wiring is complete, close the hinged door.
J
`
Do not connect the camera to a power outlet until the installation is complete.
Supplying power while the installation is in progress may cause fire or damage the
product.
Template
Insulation Sheet
<Attaching insulation sheet>
English - 37
Advertisement
Table of Contents
Troubleshooting
