Samsung Wisenet HCP-6320HAP User Manual page 38

connection & installation
y Setting up Camera DIP Switches
DIP switches for communication and ID protocols are located on the bottom of the install base.
For the switch settings, refer to the dip switch settings of this manual.
y Connecting Camera Safety Cable and attaching Camera
1. First, as shown in the left hand picture, pull out the safety cable from the base and then hook it
to the mount. The safety cable is coiled inside the base.
To attach the camera to the mount, refer to the alignment guide marks as shown in the picture.
`
2. Carefully attach the camera to the mount following the alignment guide marks as shown in the
picture.
J
`
Make sure to hook the camera's safety cable to the mount before proceeding. Otherwise you may be exposed to serious injury
caused by the camera falling.
connection & installation
38_
ID(SW1)
Protocol(SW2)
Align the Direction
Guides
Direction
Guides
Direction
Guides