Gestetner C7528 Software Manual page 268

Monitoring and Configuring the Printer
Message
Snmp over ip is ready.
Snmp over IP over 1394 is ready.
Snmp over ipx is ready.
account is unavailable:
Same account name be used.
account is unavailable:
The authentication password is not set up.
account is unavailable:
encryption is impossible.
trap account is unavailable.
snmpd start.
started.
Started.
Terminated.
The print server received error <error number>
during attempt to log in to the network. Access
to the network was denied. Verify that the print
server name and password are correct.
usbd is disabled.
WINS wrong scopeID=<scope ID>
WINS name registration: No response to serv-
er(WINS server sddress)
❒ For details about UNIX commands and parameters, see UNIX Supplement.
❒ For details about "syslog" command, see
Problem and solutions
Communication over TCP/IP with snmp is
available.
Communication over IP over 1394 with snmp
is available.
Communication over IPX with snmp is avail-
able.
User account is disabled. This could be be-
cause it use the same account name as the
administrator account.
User account is disabled. This could be be-
cause the authentication password is not set,
and only the encryption account is set.
Encryption is not possible and account is dis-
abled. This could be because:
• Security option is not installed.
• Encryption password has not been speci-
fied.
v3Trap cannot be sent. This could be because
the Trap destination account is different from
the account specified by the printer.
The snmpd service has started.
The direct print service has started.
The rendezvous function is enabled.
The rendezvous function is disabled.
Login to the file server failed. The print server
is not registered or a password is specified.
Register the print server without specifying a
password.
Plug and Play function and printing is disabled
because usbd is disabled in the security mode.
Enable usbd in the security mode.
The scope ID is incorrect.
Specify the correct scope ID.
There was no response to the registration re-
quest from the server. Check that the WINS
server address is correct and the WINS server
is working properly.
p.241 "syslog".
268