Gestetner C7528 Software Manual page 182

Making Printer Settings Using the Control Panel
• 100Mbps Half D.
• 100Mbps Full D.
❒ Default: Auto Select
❖ LAN Type
You can select Ethernet or IEEE 802.11b for LAN Type.
This menu appears only when the optional 802.11 interface unit is in-
stalled.
• Ethernet
• IEEE 802.11b
❒ Default: Ethernet
❖ IEEE 1394 Setup
You can make settings for IEEE 1394. This menu appears only when the op-
tional IEEE 1394 board is installed.
For details about IEEE 1394 Setup, see Setup Guide.
❖ DHCP 1394
You can select [On] or [Off] to use TCP/IP with DHCP.
• On
• Off
❒ Default: On
❖ IP Address1394
You can specify the IP address for IEEE 1394 (IP over 1394).
❒ Default: 0.0.0.0
❒ When using both Ethernet and IP over 1394 simultaneously, do not
specify the IP address used for Ethernet.
❖ Subnet Mask1394
You can specify the subnet mask for IEEE 1394 (IP over 1394).
❒ Default: 0.0.0.0
❒ When using both Ethernet and IP over 1394 simultaneously, do not
specify the subnet mask used for Ethernet.
182