Gestetner C7528 Software Manual page 226

Monitoring and Configuring the Printer
❖ Configuration
msh> ifconfig "interface_name" "parameter" "address"
• If you did not enter an interface name, it is automatically set to the Ethernet
interface.
• ip1394 can be specified only when the IEEE 1394 interface is installed.
• wlan can be specified only when the IEEE 802.11b interface is installed.
Interface name
ether
ip1394
wlan
❖ Netmask configuration
msh> ifconfig "interface_name" netmask "address"
❖ Broadcast address configuration
msh> ifconfig "interface_name" broadcast "address"
❖ Changing the Interface
msh> ifconfig "interface" up
• You can specify either the Ethernet interface or IEEE 802.11b interface
when using the optional IEEE 802.11b interface unit.
You cannot specify the IEEE 1394 interface.
The following explains how to configure an IP address 192.168.15.16 on
Ethernet interface.
msh> ifconfig ether 192.168.15.16
The following explains how to configure a subnet mask 255.255.255.0 on
Ethernet interface.
msh> ifconfig ether netmask 255.255.255.0
❒ To get the above addresses, contact your network administrator.
❒ Use the default configuration if you cannot obtain setting addresses.
❒ The IP address, subnet mask and broadcast address are the same as that for
the ethernet interface and IEEE 802.11b interface.
❒ When installing the optional 1394 Interface board, set the IP address and sub-
net mask so that it does not overlap with the ethernet interface or the IEEE
1394 interface.
❒ TCP/IP configuration is the same for both Ethernet and IEEE 802.11b inter-
face. If interfaces are changed, the new interface inherits the configuration.
❒ Use "0x" as the initial two letters of a hexadecimal address.
Interface configured
Ethernet Interface
IEEE 1394 Interface
IEEE 802.11b Interface
226