Gestetner DSc224 Network Manual page 120

Appendix
Parameter
auth [open|shared]
rate [auto|11m|5.5m|2m|1m]
Note
❒ When changing the Interface to IEEE 802.11b, see p.103 "TCP/IP address"
❒ When configuring the IEEE 802.11b TCP/IP, see p.103 "TCP/IP address"
Job Spool
7
Use this command to configure Job Spool settings.
Limitation
❒ You can only specify the LPR and IPP protocol.
Note
❒ This machine information cannot reload automatically when you confirm the
Job spool settings on the Web Browser. Click [Reload] or [Refresh] on the Web
Browser when you want to reload this machine information.
❖ ❖ ❖ ❖ Reference
The job spool setting appears.
msh> spoolsw
❖ ❖ ❖ ❖ Job Spool Setting
msh> spoolsw spool {on | off}
Note
❒ Specify "on" to enable the job spool function or "off" to disable it.
❖ ❖ ❖ ❖ Clearing Spool Job
If the machine is turned off accidentally during a spool job, you can specify
whether the job will be reprinted when the printer is turned back on.
msh> spoolsw clearjob {on |off}
114
Value to be configured
You can set the authorized mode when using
WEP. The specified value and the authorized
mode are as follows:
open: Open system authorized (default)
shared: Shared key authorized
You can set the IEEE 802.11b transmitting
speed.
The transmitting speed you specify here is
the speed at which data is sent. You can re-
ceive data at any speed.
auto: automatically set (default)
11m: 11 Mbps fixed
5.5m: 5.5 Mbps fixed
2m: 2 Mbps fixed
1m: 1 Mbps fixed