Gestetner DSc224 Network Manual page 101

Web Browser
A A A A
Run the Web Browser.
B B B B
Type the address "http:// (IP address of the printer you want to change the
settings)".
The status of the selected printer is displayed on the Web Browser.
C C C C
Click [Configuration].
A dialog box that prompts you to type the user name and a password ap-
pears.
D D D D
Type the user name and the password, and then click [OK].
Type only the password in this dialog box. The factory default password is
"password".
E E E E
Change names and comments.
TCP/IP
A Click [General], and then type the name into the [Device Name] box and
comment into the [Comment] box.
• In the [Device Name] box, enter the name of the printer in under 13 char-
acters. The factory default name consists of "RNP" and the last 3 bytes
of the MAC address on the Network Interface Board. For example,
when the MAC address is 00:00:74:62:7D:D5, the factory default name is
"RNP627DD5". No name of 9 characters is permitted if the prefix is
"RNP". Also, when DHCP is selected as an IP address setting, the
number of characters is limited to in under 13 characters.
• In the [Comment] box, type any comment on printers in under 31 charac-
ters.
B Click the [IEEE 1394], and then type the name into the [Device Name] box
when you change the device name for IEEE 1394 (IP over 1394) interface.
• In the [Device Name] box, enter the name of the printer in under 13 char-
acters. The factory default name consists of "RNP" and the last 5 bytes
of the EUI-64 on the IEEE 1394 (IP over 1394) Interface. For example,
when the EUI-64 is 00:00:74:00:02:01:0A:66, the factory default name is
"RNP0002010A66". No name of 13 characters is permitted if the prefix
is "RNP".
Monitoring and Configuring the Printer
7
95