Toyotomi UTN-18AP User Manual page 82

++ + +++ ++ ++
You can set the temperature by hour, up to 8 hours continuously. With the " "
and " " buttons you can adjust and change the temperature. To confi rm the
desired temperature, press the "TURBO" button. To set the temperature for the
second hour repeat the same procedure.
The personalized program is stored in the memory despite the deactivation of
the air conditioner.
9 I SENSE button
Press this button to start I SENSE function and will be displayed on the
remote controller. After this function is set, the remote controller will send
the detected ambient temperature according to the controller and the unit
will automatically adjust the indoor temperature according to the detected
temperature. Press this button again to cancel I SENSE function and will
disappear.
USEFUL TIP
Please put the remote controller near user when this function is set. Do not put
the remote controller near the object of high temperature or low temperature
in order to avoid detecting inaccurate ambient temperature. When I SENSE
function is turned on, the remote controller should be put within the area where
indoor unit can receive the signal sent by the remote controller.
10 TIMER ON / TIMER OFF button
TIMER ON button
"TIMER ON" button can set the time for timer on. After pressing this button,
icon disappears and the word "ON" on remote controller blinks. Press
κbutton to adjust TIMER ON setting. After each pressing or button,
TIMER ON setting will increase or decrease 1 minute. Hold or button, 2
seconds later, the time will change quickly until reaching your required time.
Press "TIMER ON" to confi rm it. The word "ON" will stop blinking. icon
resumes displaying. Cancel TIMER ON: Under the condition that TIMER ON
is started up, press "TIMER ON" button to cancel it.
TIMER OFF button
GB
82