Toyotomi UTN-18AP User Manual page 80

position. Horizontal louver will stop at the fi xed position.
● When selecting
Horizontal louver will send air at the fi xed angle.
● Hold button above 2 seconds to set your required swing angle. When
reaching your required angle, release the button.
Note:
• may not be available. When air conditioner receives this signal,
the air conditioner will blow fan automatically.
• Press this button continuously more than 2 seconds, the main unit will
swing back and forth from up to down, and then loosen the button. The
unit will stop swinging and present position of guide lover will be kept
immediately.
• Under swing up and down mode, when the status is switched from off to
, if press this button again 2 seconds later,
directly. If press this button again within 2 seconds, the change of swing
status will also depend on the circulation sequence stated above.
8 SLEEP button
In the Cooling or Heating mode, press this button to start sleep mode. Once
you set it up, this symbol " " appears on the screen remote control. Sleep
Mode has three places to choose from, Sleep Mode 1, Sleep Mode 2, Sleep
Mode 3. To navigate through the options, press the sleep button. By pressing
it once Sleep Mode 1 " " will be activated, by pressing it twice Sleep Mode 2
" " activates, three times Sleep Mode 3 " " activates. Pressing the button for
the fourth time will disable this function and " " will disappear. If you deactivate
the air conditioner, sleep mode will be deactivated. During DRY, FAN, AUTO,
Energy Saving & "8th C Heating" functions, sleep mode is not available.
Sleep Mode 1
Sleep Mode 1 " " is available in Cooling or Heating mode. By activating this
function, the air conditioner's temperature increases by one degree per hour
in "Cooling" mode and decreases by one degree per hour in "Heating" mode.
Sleep Mode 2
Sleep mode 2 " " will only be activated during Cooling or Heating mode.
During Cooling:
air conditioner is blowing fan at fi xed angle.
80
status will switch to off status
GB