Toyotomi UTN-18AP User Manual page 103

Note: The wiring board is for reference only, please refer to the actual one.
4. Put wiring cover back and then tighten the screw.
5. Close the panel.
Step eight: Bind up pipe
1. Bind up the connection pipe, power cord and drain hose with the band.
2. Reserve a certain length of drain
hose and power cord for installation
when binding them. When binding
to a certain degree, separate the
indoor power and then separate the
drain hose.
3. Bind them evenly.
4. The liquid pipe and gas pipe should
be bound separately at the end.
Note:
§
The power cord and control wire cannot be crossed or winding.
§
The drain hose should be bound at the bottom.
Step nine: Hang the indoor unit
1. Put the bound pipes in the wall pipe and then make them pass through the
wall hole.
2. Hang the indoor unit on the wall-mounting frame.
3. Stuff the gap between pipes and wall hole with sealing gum.
indoor unit
indoor and outdoor
power cord
gas
pipe
liquid pipe
band
drain hose
connection pipe
indoor power cord
103
drain hose
band
GB