Toyotomi UTN-18AP User Manual page 79

temp. approaches the preset temp. as soon as possible.
5 / button
● Press or
(°F). Holding
controller will change quickly. On releasing button after setting is fi nished,
temperature indicator on indoor unit will change accordingly. (The
temperature cannot be adjusted in AUTO mode.)
● When setting TIMER ON, TIMER OFF or CLOCK, press
to adjust time. (Refer to CLOCK, TIMER ON, TIMER OFF buttons.) When
setting TIMER ON, TIMER OFF or CLOCK, press
time. (Refer to CLOCK, TIMER ON, TIMER OFF buttons.)
6 button
Press this button can select left and right swing angle. Fan blow angle can be
selected circularly as below:
Note:
● Press this button continuously more than 2 seconds, the main unit will swing
back and forth from left to right, and then loosen the button, the unit will stop
swinging and present position of guide louver will be kept immediately.
● Under swing left and right mode, when the status is switched from off to
, if press this button again 2 seconds later
status directly; if press this button again within 2 seconds, the change of
swing status will also depend on the circulation sequence stated above.
7 button
● Press this button can select up and down swing angle. Fan blow angle can
be selected circularly as below:
● When selecting
louver will automatically swing up and down at maximum angle.
● When selecting
button once increase or decrease set temperature 1℃
or button, 2 seconds later, set temperature on remote
no display
no display
, air conditioner is blowing fan automatically. Horizontal
, air conditioner is blowing fan at fi xed
status will switch to off
79
or button
or button to adjust
GB