Heading Data Format - Furuno SC-60 Operator's Manual

2.6.3

Heading data format

1. Turn off the processor unit.
2. Unfasten four screws from the processor unit to remove the top cover.
3. Choose the heading format of the equipment connected to the ports HDG
OUT 1, HDG OUT 2 and HDG OUT 3 with the jumper wires on the circuit
board 20P8171, referring to the table below. The default setting for each port
is AD-10.
Port
HDG OUT 1
HDG OUT 2
HDG OUT 3
Jumper wire and format on the circuit board 20P8171
Format
AD-10 J11 < - > J13
NMEA J11 < - > J12
AD-10 J14 < - > J16
NMEA J14 < - > J15
AD-10 J17 < - > J19
NMEA J 17 < - > J18
ANGULAR
RATE SENSOR
20P8171
Processor unit, cover opened, top view
Setting
NMEA and AD-10 are identified
on the circuit board. Choose
NMEA for IEC 61162-1
sentences.
NMEA
(IEC 61162)
HEAD1
AD-10
AD-10
HEAD3 NMEA (IEC 61162)
2. INSTALLATION
Remarks
NMEA (IEC 61162)
HEAD2
AD-10
2-21