Furuno SC-60 Operator's Manual page 19

3. Coat exposed parts of nuts, bolts and washers with silicone sealant.
Coating bolt, nut and washers with silicone sealant
4. Connect the three coaxial cables coming from the antenna unit to the
appropriate coaxial cables on the antenna cable, referring to the table below.
Cable from antenna
(no. marked on cable)
ANT 1
ANT 2
ANT 3
5. Cover the antenna connectors with vulcanizing tape and vinyl tape, for
waterproofing. Tie tape ends with a cable tie.
6. Set the joints of the coaxial cables into the cavity in the antenna base.
7. Pass two cable ties (long life, temperature resistant type, local supply)
through the hole shown in the figure below. Fasten them at the locations
shown in the figure below.
Cable
TTPX6-3D2V-15M
No color
Yellow
Red
Waterproofing the antenna connector
Cable Tie
How to fasten the antenna cable
Radome
base
Platform
Coat with
silicone sealant.
2. INSTALLATION
2-5