Safety Instructions - Furuno SC-60 Operator's Manual

SAFETY INSTRUCTIONS

Safety Instructions for the Operator
WARNING
Do not open the equipment.
Only qualified personnel should work inside
the equipment.
Do not disassemble or modify the
equipment.
Fire, electrical shock or serious injury can
result.
Immediately turn off the power at the
switchboard if the equipment is emitting
smoke or fire.
Continued use of the equipment can cause
fire or electrical shock. Contact a FURUNO
agent for service.
Do not place liquid-filled containers on
the top of the processor unit.
Fire or electrical shock may result if the
liquid enters the equipment.
CAUTION
No one navigation device should ever
be solely replied upon for the navigation
of a vessel.
Always confirm position against all avail-
able aids to navigation, for safety of vessel
and crew.
Use the proper fuse.
Use of a wrong fuse can result in damage
to the equipment.
Safety Instructions for the Installer
WARNING
Do not open the cover unless totally
familiar with electrical circuits and
service manual.
Improper handling can result in electrical
shock.
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Do not install the equipment where it
may get wet from rain or water splash.
Water in the equipment can cause fire,
electrical shock or damage to the equipment.
NOTICE
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Display unit
SC-602
Processor unit
SC-601/601D
Antenna unit
SC-303
Antenna unit
SC-603
DGPS beacon
antenna GR-8
i
Standard Steering
Compass Compass
0.5 m 0.3 m
1.3 m
0.8 m
0.3 m 0.3 m
0.3 m 0.3 m
0.3 m 0.3 m