Editing A Studio Set; Overall Settings For The Studio Set; Settings For Each Part - Roland FA-07 Reference Manual

Editing a Studio Set

Overall Settings for the Studio Set

Here's how to make settings that apply to the entire studio set.
1.
Press the [MENU] button .
2.
Move the cursor to "Studio Set Common"
[ENTER]
button .
The STUDIO SET COMMON screen appears.
MEMO
From the STUDIO SET PLAY screen, you can also access the
STUDIO SET COMMON screen by holding down the
button and pressing the
3.
Use the cursor buttons to select an item, and use the dial
to edit the setting .
NOTE
The edits you make to the studio set are temporary. They will be
lost if you turn off the power or select another studio set. If you
want to keep the changes, save the studio set (p. 45).
Common Parameters
MEMO
For details on the common parameters, refer to
Guide"
(PDF).
Tab Explanation
Specify the play mode, pad part, and the drum part
General
to which Comp+EQ applies.
Specify the MIDI messages used to control
Control
parameters when using tone control 1–4.
Turn this
Phase Lock between the note-on timing of parts that are played
on the same MIDI channel.
Specify the MIDI messages used to control
Pedal
parameters when using a pedal connected to the
CTRL 1 and CTRL 2 jacks.
Specify the MIDI messages used to control
S1/S2
parameters when using the
Specify the MIDI messages used to control
Knob
parameters when using the SOUND MODIFY knobs.
Specify the MIDI messages used to control
D-Beam
parameters when using the D-BEAM controller.
For each part, specify whether various controller
Control Sw
operations will be enabled (ON) or disabled (OFF).
44
and press the
[SHIFT]
[5] (Studio Common)
button.
"Parameter
"on"
if you want to minimize inconsistency
[S1] [S2] buttons.

Settings for Each Part

A studio set has 16 parts; each part has its own settings such as
volume (Level), equalizer (EQ), and key range (Keyboard).
1.
Access the PART VIEW screen (p . 26) .
2.
Use the cursor buttons to select a parameter, and use the
dial to edit the value .
To switch tabs, hold down the
[ ] [ ] buttons.
Part parameters
MEMO
For details on the part parameters, refer to
(PDF).
Tab Explanation
Specify each part's tone, level, pan, and MIDI receive
Level/Pan
settings.
Specify each part's key range, and whether the
Keyboard
arpeggiator is applied.
Specify each part's output destination, and the level
Output/EFX
of signal that is sent to chorus and reverb.
EQ Edit the equalizer that is applied to each part.
Pitch Specify each part's pitch and portamento setting.
Scale Tune Specify the scale tune settings of each part.
Vibrato Edit each part's vibrato settings.
Specify offsets for parameters such as cutoff and
Offset
resonance.
Mono/Poly/Legato Edit each part's mono, poly, and legato settings.
Specify the number of voices that are reserved for
Voice Reserve
each part.
Specify the MIDI messages that are received by each
MIDI Rx Filter
part.
*
Depending on the sound, some part parameters have no effect.
[SHIFT]
button and use the cursor
"Parameter Guide"