Saving A Studio Set; Initializing A Studio Set (Studio Set Init); Initializing A Part (Part Init) - Roland FA-07 Reference Manual

Saving a Studio Set

Edits you make to a studio set are temporary. They are lost if you
turn off the power or select another studio set. If you want to keep
the changes you make, save the studio set.
NOTE
When you save the studio set, the data that was previously in
the save-destination is overwritten.
1.
Press the [WRITE] button .
The WRITE MENU window appears.
2.
Move the cursor to "Studio Set"
button .
3.
Use the dial or the [DEC] [INC]
save-destination .
4.
Press the [2] (Rename) button and assign a name .
Controller Explanation
[DEC] [INC]
Dial or Specify the character that you want to enter.
Move the cursor.
[ ] [ ]
Switch between uppercase and lowercase
[ ] [ ]
alphabetical characters.
[4] (Delete) Deletes the character at the cursor location.
[5] (Insert)
Inserts a space (blank) at the cursor location.
[6] (Cancel) Cancels input and exits the naming screen.
[7] (OK)
Confirms the name.
5.
Press the [7] (OK) button .
6.
[7] (Write)
Press the button .
A confirmation message appears.
If you decide to cancel, press the
7.
Press the [6] (OK) button .
The studio set is saved.
NOTE
Never turn off the power while data is being saved.
and press the [ENTER]
buttons to select the
[7] (Cancel) button.
Initializing a Studio Set (Studio Set
Init)
Here's how to initialize the currently selected studio set.
1.
Press the [MENU] button .
2.
Move the cursor to "Studio Set Init"
[ENTER]
button .
3.
Select the content that you want to initialize, and then
[7] (Select)
press the button .
Parameter Explanation
Studio Set
All settings of the studio set are initialized.
Each part's vibrato and the following offset
parameters are initialized.
• Cutoff Offset
• Resonance Offset
• Attack Offset
Sound Control
• Decay Offset
• Release Offset
• Vibrato Rate
• Vibrato Depth
•
Vibrato Delay
A confirmation message appears.
If you decide to cancel, press the
4.
Press the [6] (OK) button .
The studio set is initialized.
NOTE
Never turn off the power while initialization is in progress.

Initializing a Part (Part Init)

Here's how to initialize the part settings of the current part.
1.
In the PART VIEW screen (p . 26), press the
button .
A confirmation message appears.
If you decide to cancel, press the
2.
[6] (OK)
Press the button .
The part is initialized.
* The Voice Reserve setting is not initialized.
NOTE
Never turn off the power while initialization is in progress.
Editing a Studio Set
and press the
[7] (Cancel) button.
[5] (Part Init)
[7] (Cancel)
button.
45