Saving Your Performance Settings (Registration); Settings That Are Saved In A Registration; Recalling And Editing A Registration; Saving Current Settings Into A Registration - Roland MP200 Owner's Manual

Saving Your Performance Settings
(Registration)
Lets you register your favorite performance settings so that you can
easily recall those settings while you perform.
Such settings are called a "Registration. " You can save a total of 36
registrations, 9 each in buttons [1]-[4]. These 36 registrations are
collectively called a "Registration set. "
1-9 2-9 3-9
1-1 2-1 3-1 4-1
36 registration
Registration set

Settings That Are Saved in a Registration

Setting
The selected tone (including Split or Dual tones)
Ambience
Rotary Speed
Key Touch
Transpose
Split on/off
Split point
Left Shift
Right Shift
Dual on/off
Tone 1 Shift
Tone 2 Shift
Balance (Split, Dual)
Twin Piano on/off
Twin Piano Mode
Damper Pedal Part
Center Pedal
Left Pedal
MIDI Transmit Ch.
4-9
Page
p. 8, p. 8
p. 17
p. 8
p. 17
p. 10
p. 8
p. 8
p. 8
p. 8
p. 9
p. 9
p. 9
p. 8
p. 9, p. 25
p. 9, p. 25
p. 26
p. 26
p. 26
p. 27

Recalling and Editing a Registration

1 .
Press the [Registration] button.
2 .
Press a number button ([1] to [4]) to choose the
location where the desired registration is saved.
3 .
Turn the [ ] knob to select the registration
variation.
The selected registration is recalled.
MEMO
You can also use a pedal to recall registrations (p. 27).
4 .
To edit the selected registration, press the [ ] knob
and then turn the [ ] knob toward the right.
MEMO
If you press the [Registration] button to exit the Registration
screen, you will return to the state prior to recalling the
registration.

Saving Current Settings into a Registration

NOTE
When you save a registration into a location, it will overwrite any
registration already stored at that location.
1 .
While holding down the [Registration] button,
press a button from [1] to [4] to select a registration
and then turn the [ ] knob to select a registration
variation.
2 .
Rename the registration.
Select the character
which you want to Turn the [ ] knob
change
Press the [ ] knob (confirm)
/
Change the character
Turn the [ ] knob (change the character)
/
Press the [ ] knob (back)
Insert one character Press the [s] button
Delete one character
Press the [7] button
If you decide to cancel, press the [ ] button.
Turn the [ ] knob to select the ( at the right
3 .
edge of the screen, and then press the [ ] knob to
confirm.
The registration is saved.
NOTE
Never turn off the power while the screen indicates "Executing... "
Performing
11