Shortening Scene Group Switching Time - Omron F160 Operation Manual

Customizing Operations
Display Capture Results
Captured display
0.Scn 0 MON OK 67ms
OK
Freeze
STEP/TRG:Msr S+↑ ↓:Mem img
5-4-2

Shortening Scene Group Switching Time

Precaution
SeeAlso
When display capture is executed, a directory called IMAGE will automatically
be created in the root directory of the Memory Card and the following two
types of files will be stored in that directory.
LIVE∗∗∗.BMP
CAPT∗∗∗.BMP
0.Scn 0 MON
OK
STEP/TRG:Msr S+↑ ↓:Mem img
A serial number starting from 000 will be automatically allocated to ∗∗∗.
The same number is used for both files.
Normally, settings data is saved to flash memory and the Memory Card when
scene groups are changed. The time taken to save is, therefore, added to the
time taken to change scene groups. The time to change scene for changes in
measurement setups can be reduced by omitting the save process.
If this function is set to OFF and settings data changed, always save the data
before changing scene groups. When scene groups are changed, data from
the flash memory or the Memory Card is loaded. So if the changed settings
data is not saved, the data will be replaced by the loaded data. Refer to
page 86.
1. Enter System mode and select Operation settings.
Refer to page 102.
The Menu will be displayed.
Set key operation
Display capture
Setting menu masking
Processing item masking
Save at switch Scn Group
Password
2. Select Save at switch Scn Group.
Density images with 256 graduations will
be saved in bitmap format. These images
can be loaded to the F160 and re-
measured. (Binary images will also be
saved in bitmap format.)
OK 67ms
The displayed image will be saved in a
bitmap. (The image will only have 192
graduations.)
Only this file will be saved if the image was
captured while in Set, System, or Tool
Freeze
modes.
Section 5-4
109