Lan Setting; Setting Lan Host Parameters; Configuration The Dhcp Server - Zte WF820+ User Manual

3.5 LAN Setting

3.5.1 Setting LAN Host Parameters

By default, the IP address is 192.168.1.1 with a subnet mask of 255.255.255.0. You can change the
host IP address to another individual IP address that is easy to remember. Make sure that IP address
is unique on your network. If you change the IP address of the CPE, you need to access the web
management page with the new IP address.
To change the IP address of the CPE, perform the following steps:
1. Choose Network Setting>LAN Settings.
2. In the LAN Host Settings area, set IP address and subnet mask.
3. In the DHCP Setting area, set the DHCP server to Enable.
4. Click Submit. As shown in Figure 3-10.

3.5.2 Configuration the DHCP Server

DHCP enables individual clients to automatically obtain TCP/IP configuration when the server powers
on. You can configure the CPE as a DHCP server or disable it. When configured as a DHCP server, the
CPE automatically provides the TCP/IP configuration for the LAN clients that support DHCP client
capabilities. If DHCP server services are disabled, you must have another DHCP server on your LAN,
or each client must be manually configured.
To configure DHCP settings, perform the following steps:
1. Choose Network Setting > LAN Settings.
2. Set the DHCP server to Enable.
3. Set Start IP address.
This IP address must be different from the IP address set on the LAN Host Settings area, but
Figure 3-10