Table of Contents
Advertisement
6.
Set Security.
If Security is set to NONE (not recommended), Wi-Fi clients directly connect to the CPE.
This security level is low.
If Security is set to WEP, Wi-Fi clients connect to the CPE in web-based encryption mode.
If Security is set to WPA-PSK, Wi-Fi clients connect to the CPE in WPA-PSK encryption
mode.
If Security is set to WPA2-PSK, Wi-Fi clients connect to the CPE in WPA2-PSK
encryption mode. This mode is recommended because it has a high security level.
If Security is set to WPA-PSK & WPA2-PSK, Wi-Fi clients connect to the CPE in WPA-
PSK&WPA2-PSK encryption mode.
7.
Set the encryption mode.
If...
Sets to
WEP
Authentication mode
Encryption password
length
password index
WPA-PSK
WPA-PSK
WPA encryption
WPA2-
WPA-PSK
PSK(recommen
ded)
WPA encryption
WPA-PSK &
WPA-PSK
WPA2-PSK
WPA encryption
8.
Click Submit. As shown in Figure 4-3.
Description
Current
This value can be set to 1, 2, 3, or 4. After a key
index is selected, the corresponding key takes
effect.
Only 8 to 63 ASCII characters or 8 to 64 hex
characters can be entered.
This value can be set to TKIP+AES, AES, or
TKIP.
Only 8 to 63 ASCII characters or 8 to 64 hex
characters can be entered.
This value can be set to TKIP+AES, AES, or
TKIP.
Only 8 to 63 ASCII characters or 8 to 64 hex
characters can be entered.
This value can be set to TKIP+AES, AES, or
TKIP.
Shared authentication: The client
connects to the CPE in shared
authentication mode.
Open authentication: The client connects
to the CPE in open authentication mode.
Both: The client connects to the CPE in
shared or open authentication mode.
128bit: Only 13 ASCII characters or 26
hex characters can be entered in the Key 1
to Key 4 boxes.
64bit: Only 5 ASCII characters or 10 hex
characters can be entered in the Key 1 to
Key 4 boxes.
Advertisement
Table of Contents
