Table of Contents
Advertisement
3.4.7 Verifying the PUK
If PIN verification is enabled and the PIN fails to be verified for three consecutive times, the
PIN will be locked. In this case, you need to verify the PUK and change the PIN to unlock it.
To verify the PUK, perform the following steps:
1.
Choose Network> PIN Management.
2.
Enter the PUK in the PUK box.
3.
Enter a new PIN in the New PIN box.
4.
Repeat the new PIN in the Confirm PIN box.
5.
Click Submit.
3.5 LAN Setting
3.5.1 Setting LAN Host Parameters
By default, the IP address is 192.168.1.1 with a subnet mask of 255.255.255.0. You can change
the host IP address to another individual IP address that is easy to remember. Make sure that IP
address is unique on your network. If you change the IP address of the CPE, you need to access
the web management page with the new IP address.
To change the IP address of the CPE, perform the following steps:
1.
Choose Network Setting>LAN Settings.
2.
In the LAN Host Settings area, set IP address and subnet mask.
3.
In the DHCP Setting area, set the DHCP server to Enable.
4.
Click Submit. As shown in Figure 3‐13.
Figure 3‐13
Advertisement
Table of Contents
