Vivotek Network Camera FD7141(V) User Manual page 9

Wall mount with the bottom base
1� Attach the supplied Alignment sticker to the wall�
2. Through the 10 circles on the sticker, drill 2 pilot holes symmetrically on each side into the
wall� Then Hammer the supplied four plastic anchors into the holes�
3. Through four holes on the bottom base, insert the supplied four screws to corresponding
holes and secure the bottom base with a screwdriver�
4. Feed the cables through hole A or B. If you want to use hole B, remove the rubber with a
screwdriver�
5� Secure the camera base to the bottom base with supplied three screws�
VIVOTEK - A Leading Provider of Multimedia Communication Solutions
3
2
4
B
5
1
A
User's Manual - 9