Installation 8; Hardware Installation - Vivotek Network Camera FD7141(V) User Manual

VIVOTEK - A Leading Provider of Multimedia Communication Solutions
Installation

Hardware installation

First, use a screwdriver to loose three screws and detach the dome cover from the camera
base. Then, follow the steps below to install the camera; either to a ceiling or to a wall.
Ceiling mount with the bottom base
1� Attach the supplied Alignment sticker to the ceiling�
2. Through the 10 circles on the sticker, drill 2 pilot holes symmetrically on each side into the
ceiling� Then hammer the supplied four plastic anchors into the holes�
3. Through four holes on the bottom base, insert the supplied four screws to corresponding
holes and secure the bottom base with a screwdriver�
4. Feed the cables through hole A or B. If you want to use hole B, remove the rubber with a
screwdriver�
5� Secure the camera base to the bottom base with supplied three screws�
1
8 - User's Manual
A
2
B
4
3
5